Saturday, 28 September 2013

Earrings from recycled floppy disk

Needed glue, paint finishing with water or diluted PVA glue, nuns, floppy disks , cardboard, paper cutouts. 

From cardboard (I used the one located inside the tights) and the gift card draw circles with radius of 1.2 cm.

Glue with PVA glue the two circles and drying finish completed with water varnish or PVA glue diluted with water.


Open yourself the floppy and remove the magnetic disk is inside, remove the metal pin.
With the help of an awl pierces you the outer edge of the metal pin and insert the ring which will be hooked up to the nun earring.
With a hammer trying to flatten the central hole of the pin and then applied the glue and attach the circle of paper.

Easy create colorful pots with cans and pegs


Zip idea

Here is my first jewelry made ​​with the creative recycling of zippers . A few mornings ago I was thinking that it was their moment, but I had no clear idea of exactly what I wanted to achieve. The  I took her in my hands, I began to observe them, then I turn and stir, but nothing ... the idea did not come.
Suddenly I noticed that the teeth of the zip are empty and with a fine needle I tried to pass a thread: eureka, it works!  's so that came out of this bracelet, we now see in detail what is required and how to do it.
You will need:
  • 2 very thin needles 
  • nylon thread of 0.25 mm
  • a zipper with nylon teeth (teeth in metal and plastic were not pierced)
  • swarovski beads or other gender
  • cups to close
  • metal wire from 0.6 mm
  • a closure
Cut about one meter of nylon and puts the two leaders in the needles.
Remove the metal clip that is at the end of the zipper and open it so as to separate the teeth that constitute the main body of the hinge itself.  sticks a needle in a tooth to the right and the other needle in the tooth of the left symmetrically opposite.
In the left-hand threads on one wire swarovski

Now pass the needle with the thread right inside the swarovski
The wires inside the swarovski will cross, pulls the strings so as to bring the two tapes.
(A) Proceed by sliding the needles and wires in the next three teeth  
(B) on the wire threader left one swarovski
(C) Thread with swarovski right in, pull ...
Proceed repeating steps (A) (B) (C) until you reach the desired length

Once you have finished working, go back doing wipe the threads in the needles and the swarovski, in this way will remain blocked, cut the wire in surplus.
Cut the ribbon as shown in the picture.
Wrap a piece of wire from 0.6 mm on entambe ends, puts a bowl and make a 'closed loop .  Snap the snap and you're done.

And if you have a zip longest you can make a double bracelet like this.

cola cap (idea)



use your mind not money to buy bags


cola bottle convert into baby toy


Easy to do


Thursday, 26 September 2013

What do you think of this? A wheelchair bike..


best way to keep your fingars safe


gift idea

Just put polymer clay shapes onto a glass jar, then bake for 10 minutes...

its reading time


yummy hmmm


baby memories


in all size!!


Idea that makes your kid happy


be creative!


Gorgeous!


IDEA painting giant flowers on the walls of the toilet. Gorgeous! It's one of those 

decorations that end up being the center of attention for the beauty and originality.


summer reuse the icecream sticks and be ceative ...


its make your room more colorful